Can My Neighbours Guttering Overhangs My Property?

Can my Neighbour build right to my boundary?

The short answer is “yes, subject to serving a valid notice and following the processes set out in The Party Wall Act.

The party wall act only applies to “structures” (ie: a wall with a foundation), it does not apply to timber fences or other screens..

How much should shingles overhang drip edge?

Shingles should not extend more than 3/4” (19 mm) past the drip edge. If shingles overhang the edge of the roof by more than 3/4” (19 mm), then they are not supported and may crack and break off. In addition, the wind resistance at the roof edge may be compromised.

What is the difference between drip edge and rake edge?

Drip edge and rake edge are the first parts of the roof system to be installed. They form a long, narrow piece of metal, which is installed along the perimeter your Roof Deck. Drip edge goes along your eaves trough areas and rake edge goes along your gable ends.

Why is water dripping between gutter and fascia?

Water Gets Behind the Gutter If water is dripping behind your gutter, it’s probably because it was installed without any flashing over the back of the gutter. The gutter apron will prevent the dripping. A gutter apron is a bent piece of flashing that tucks up under the shingles and over the gutter.

Are gutters tenants responsibility?

“During a tenancy, the landlord/owner is responsible for cleaning the gutters,” she said. “This [gutter cleaning] is a maintenance item that the owner is required to undertake as part of their upkeep on a property.”

Can my Neighbour drain water on my property?

To reduce the risk of flooding to neighbouring properties, the law requires that you: Keep your drains clear in your property and to ensure that you do not drain water into your neighbour’s property or foul drain. … But you are not allowed to artificially channel water a way that will cause damage your neighbour’s land.

How far can Eaves overhang?

Overhangs can vary from a few inches to a few feet depending on preference; however, the suggested width of an overhang is between 12” and 18” for eaves and no more than 8” for rakes. That said, overhangs can extend as far as 2′ without the need for external supports.

Can drip edge be installed after shingles?

The drip edge is often replaced when new shingles are installed, but it can be replaced at any time. Asphalt roof shingles can become brittle in cold weather, so wait until a warm (but not hot) day to remove and replace eave stripping.

Can a neighbor drain water onto your property?

Landowners can take whatever steps they wish, such as building dikes or drainage ditches. If surface water runs from your neighbor’s land onto your land, causing more damage than natural, you are still expected to protect your land from this water.

What is an eave overhang?

The eaves are the edges of the roof which overhang the face of a wall and, normally, project beyond the side of a building. The eaves form an overhang to throw water clear of the walls and may be highly decorated as part of an architectural style, such as the Chinese dougong bracket systems.

How much should a gutter overhang?

We recommend 50mm overhang into a standard gutter.

Who is responsible for shared guttering?

Normally as a rule of thumb is if it’s attached to your property then it’s your responsibility. You and your neighbour would therefore be responsible for the down pipes on your sides and 1/2 the gutter at the front and 1/2 at the back.

Should shingles overhang the drip edge?

Asphalt shingles should overhang the exterior edge of the drip edge by ¼ to ¾-inch. Check local building code for drip edge requirements prior to the start of your roofing project.

Can eaves overhang an easement?

SIMPLY: an easement that allows the eaves on one building to overhang the boundary of the land into the ownership of another.

Do you install gutter under drip edge?

It is recommended that gutters are placed under or ‘behind’ the drip edge of your roof. A drip edge refers to a component that hangs over the roof and has an outward projecting lower edge.

How far should gutters be above drip edge?

MISTAKE #4 – Improperly Locating the Gutter When choosing gutters, consider the material, as well as the size and width needed. Your gutter needs to be a few inches under the edge of your roof.

Which is better drip edge or gutter apron?

for installing on an existing roof, use a drip edge. A drip edge can be easily installed and there will be no need of lifting the shingles. On the other hand, installing a gutter apron on the existing roof is not possible. As it will require you to lift the shingles which are just not possible.